Gpstracker.net.in
Freedom is lost now…!
Send SMS “pSpace+your local APN” via a cell phone and if succeeded, the
tracker will reply “APN OK”
6.36.1.3
E.g. Send SMS command “APNONE123456 airtelgprs”. If succeeded, tracker will reply
“APN OK”
Notes: 123456 refer to password of tracker and airtel is the APN provider
6.36.3 Configure IP and Port
6.36.3.1
. Send SMS as below via a cell phone: pSpace+IPSpace+Port Number. If
succeeded, “adminip OK” is returned by the device in SMS.
6.36.3.2
E.g. Send SMS command “adminip123456 37.59.232.31 10200” to the tracker device, If succeeded,
“adminip OK” is returned by the device in SMS. ( 123456 is default password
，
37.59.232.31 is
IP
，
10200 is port).
6.37. Less GPRS traffic
6.37.1 Tracker will change to less GPRS traffic mode after parking 5 minutes (ACC is OFF), GPRS disconnect
and connect again when alarm being triggered or vehicle starts driving.
6.37.2 Activate this function: Send "less gprs123456 on", tracker will reply "less gprs on ok".
6.37.3 Deactivate this function: Send "less gprs123456 off", tracker will reply" less gprs off ok".
Note: 123456 is the password of tracker, and replace it with the new if you have changed.
6.38. Modes Switch between “SMS” and “GPRS”
6.38.1
The default mode is “SMS”
6.38.2
Send SMS “GPRS+password” to the unit, and it will reply “GPRS ok!” it means tracker device has
switched to “GPRS” mode.
6.38.3
Send SMS “SMS+password” to the unit, it will reply “SMS ok!” and restore to “SMS” mode.
。
6.39 Set up monitor center number
6.39.1 Setup: send command “cepspace+number” to tracker, it will reply“centernum ok”.
After setup monitor center number, the messages of auto track by sms will be set to this center number, if all
alarms need to be sent to this number too, then this center number must be setup as authorized number.
6.39.2 Cancel: Send “nocepassword” to tracker, it will reply “no center num ok”.
7
．
Cautions
Please comply with the instructions to extend the unit life:
1. Keep the unit dry. Any liquid, i.e. rain, moisture, may destroy or damage the inside circuitry.
2. Don’t use & store the unit in dusty places.
3. Don’t put the unit in overheated or overcooled places.
4. Handle carefully. Don’t vibrate or shake it violently.
5. Clear the unit with a piece of dry cloth. Don’t clean in chemicals, detergent.
6. Don’t paint the unit, this may cause some foreign materials left in between the parts.
7. Don’t disassemble or refit the unit.
8. Please read the user manual carefully before installation and operation, learn something more about the
voltage range. Otherwise, it won’t work properly or destroy the product.
8
．
Faults & the Solutions
