Ingo Maurer PROTOTYPE, Инструкция по эксплуатации

Страница: 4 / 8

6 7
Prototype is available in three versions:
Version 1:
with metal base, Ø 22 cm.
Version 2:
with clamp fitting.
Version 3:
floor lamp.
Caution:
Do not connect the lamp to the power supply
until the assembly is complete!
Assembly
Version 1:
Fit the lamp body over the pin (
1
) in the metal base.
1
Version 2:
Inser t the preassembled clamp (
2
) in the opening (
3
) of
the cylindrical base (
4
) and press it in until it reaches the
stop. Fasten the clamp to the table surface by tightening
the knurled screw (
5
). Fit the lamp body over the pin (
6
) in
the cylindrical base (
4
). 2
Version 3:
Screw the rod firmly into the base and make sure that it
is securely in place. Fit the lamp on the rod.
3
Important:
Ensure that the internal spring-loaded catch
locks in place!
Assembling the reflector and
inserting the bulb
Caution:
Do not touch the new bulb with your bare
hands (risk of fingermark damage).
Fit the silicone shade (
7
) over the reflector (
8
).
4
Pull the silicone nipple (
9
) into the reflector as shown in
fig.
5
. Inser t the bulb. Slide the reflector sleeve (
10
)
over the lamp holder (
11
) until it reaches the stop.
6
Adjusting the lamp
The lamp is rotatable through 360°. The horizontal arm
swivels up or down by 90° or 80 cm. The head of the
lamp swivels through 100°; the reflector rotates through
360° around the bulb.
Changing the bulb
Caution:
Unplug the lamp and allow it to cool down
completely! Do not touch the new bulb with your bare
hands (risk of fingermark damage).
Once the reflector (
8
) has cooled down, detach it from
the holder (
11
), together with the silicone shade, and
remove the spent bulb. Insert the new bulb and slide the
reflector sleeve (
10
) over the lamp holder (
11
) until it rea-
ches the stop.
6
Cleaning
The silicone shade (
7
) can be cleaned with soapy water ;
other par ts may be wiped with a damp cloth. The gradual
yellowing of the shade is due to natural ageing of the
material and is a deliberate feature of the lamp.
Technical specification
230 volts, max. 75 watts. 125 volts, max. 60 watts. High-
pressure halogen bulb, G 9 base.
Minimum distance from combustible surfaces:
0.3 m
This symbol on the reflector means that only
low-pressure light bulbs may be used.
Any repairs that may become necessary must be carried
out by a qualified electrician.
English English