Ingeteam INGEREV RAPID ST Series, Инструкция по установке и эксплуатации

Страница: 19 / 48

ABX2011IQM01_ - Installation and Operation Manual
FC1
16 A
FB1
30 mA
M01
4 A
TA1
24 Vdc
TA2
CHADeMO
12 Vdc
TA3
GENERAL
12 Vdc
XD3 XD3 XD5
FC2
6,3 A
Ir = 4~6,3 A
FC3
4 A
Curve C
FC4
10 A
Curve C
FB2
30 mA
KF1
230 Vac
Water pump
Ground fault detector
Cooling/heating
230 V
ac service plug
230 Vac
12 Vdc 12 Vdc 12 Vdc
Single line of the auxiliary system
2.12. Electrical diagram of the DC power circuit
The INGEREV RAPID ST family units are connected to a direct voltage (DC) distribution network. DC voltage
isolating elements are located outside the unit and are part of the customer’s installation.
In order to avoid opening the unit without having disconnected the direct voltage, a limit switch is included whose
contact must be wired with the minimum coil of the corresponding disconnector. In this way, in case of opening
the unit door, the disconnector supplying said unit will trip, thus being isolated from the DC network.
CAUTION
Opening the unit enclosure does not imply the absence of dangerous voltages inside.
This applies mainly to the DC power circuit. Due to the presence of capacities, dangerous DC voltages can
exist even several minutes after the supply has been disconnected. It is essential to wait 10 minutes between
disconnecting the DC power and opening the unit door.
The power modules (-U10 and –U20) are connected to the DC distribution busbars (points 2 and 3). The output of
the modules is connected to the hose selection contactors (-Kout1 and -Kout2) using high-density cables. Parallel
contactors (-Kpar) allow both power modules to be connected to only one of the charging sockets.
19
Unit description Ingeteam