941256_00(1) Page 4 of 4
DOGGING INDICATOR FUNCTIONAL TEST
8
Install new cover plate and cut to proper length (if required).
Cut flush to mechanism case
(minimum cover plate length is 8-7/8”)
9
Install the end cap.
End cap
Note: Hex dogging shown below. Cylinder
dogging is the same except it uses key in
cylinder rather than hex key in hole.
1. Depress pushbar and hold.
2. Place hex key in hole as shown and turn
clockwise. Push bar stays in down position.
3. Device is now dogged and indicator light
should not be flashing.
CW
4. To undog device, place hex key in hole as
shown and turn counterclockwise releasing
pushbar.
5. With device undogged, light should flash
every 5 seconds.
Hex key
CCW
Indicator light
Remove anti-rattle clip if
necessary for cutting
Anti-rattle clip
2” minimum
When battery is low, the indicator light will double flash every 5 seconds. Then the batteries
should be changed within 3 days.
BATTERY LOW INDICATION
Key removed during
installation
DOGGED - NOT FLASHING
UNDOGGED - FLASHING
