Ingersoll-Rand P250WJDU, Руководство по эксплуатации и техническому обслуживанию

Страница: 38 / 57

Operating & Maintenance Manual Maintenance
40 Book: 22904767 (6/06) Rev. A
Maintenance
CAUTION
!
Any unauthorized modification or
failure to maintain this equipment may
make it unsafe and out of factory
warranty.
If performing more than visual
inspections, disconnect battery
cables and open manual blowdown
valve.
Use extreme care to avoid contacting
hot surfaces (engine exhaust manifold
and piping, air receiver and air
discharge piping, etc.).
Never operate this machine with any
guards removed.
Inch and metric hardware was used in
the design and assembly of this unit.
Consult the parts manual for
clarification of usage.
NOTICE
Disregard any maintenance pertaining
to components not provided on your
machine.
General
In addition to periodic inspections, many of
the components in these units require
periodic servicing to provide maximum
output and performance. Servicing may
consist of pre-operation and post-operation
procedures to be performed by the operating
or maintenance personnel. The primary
function of preventive maintenance is to
prevent failure, and consequently, the need
for repair. Preventive maintenance is the
easiest and the least expensive type of
maintenance. Maintaining your unit and
keeping it clean at all times will facilitate
servicing.
Scheduled Maintenance
The maintenance schedule is based on
normal operation of the unit. This page can
be reproduced and used as a checklist by the
service personnel. In the event unusual
environmental operating conditions exist, the
schedule should be adjusted accordingly.
Compressor Oil Level
The oil level should be checked before the
unit is started. Always check the oil level
while the unit is level, the engine off, and
there is zero pressure in the separator tank.
The optimum oil level is with the pointer at the
top of the green section on the level gage.
Add oil if the pointer reaches the bottom of
green section.
NOTE: The oil level gage
will not read properly while
the engine is running.