Ingersoll-Rand MHP3238, Информация по техническому обслуживанию продукции

Страница: 4 / 12

INSPECTION REPORT
Ingersoll Rand MLK Air Hoist
Model Number: Date:
Serial Number: Inspected by:
Reason for Inspection: (Check Applicable Box)
1. Scheduled Periodic Inspection ( ___ Quarterly ___ Semiannually ___ Yearly)
Operating Environment:
Normal ___ Heavy ___ Severe ___
2. Discrepancy(s) noted during Frequent Inspection
3. Discrepancy(s) noted during maintenance
4. Other: ___________________________
Refer to the Product Information and Parts Information Manual and “INSPECTION” section for the general inspection criteria. Also, refer to appropriate National Standards
and Codes of Practice. If in doubt about an existing condition, contact the nearest Ingersoll Rand distributor or the factory for technical assistance.
COMPONENT
CONDITION CORRECTIVE ACTION
NOTES
Pass Fail Repair Replace
Fasteners
Gears
Shafts
Bearings ---
Load Bearing Wheel
Hook Block/Double-Reeved Pocket
Wheel
Chain Guides
Springs ---
Covers, Housings
Hooks ---
Top
Actual Hook Throat Width: ________ inches / ________ mm
(Refer to Table 4 ‘Load Chain Normal and Discard Length’ on page 2 for minimum/maximum acceptable widths.)
Hook Twist
--- (maximum 10%)
Hook Crack Test Method Used: Dye Penetrant ________ Magnetic Particle ________ Other: ________
Bottom
Actual Hook Throat Width: ________ inches / ________ mm
(Refer to Table 4 ‘Load Chain Normal and Discard Length’ on page 2 for minimum/maximum acceptable widths.)
Hook Twist
--- (maximum 10%)
Hook Crack Test Method Used: Dye Penetrant ________ Magnetic Particle ________ Other: ________
Hook Latch ---
Brake (100% Load Test) ---
Brake (Visual Inspection)
Tail Pin (End Anchor)
Load Chain: ---
Working length(s) maximum wear: ________ inches / ________ mm
(Refer to Table 4 ‘Load Chain Normal and Discard Length’ on page 2.)
Supporting Structure
Labels and Tags ---
Other Components (List in NOTES
section)
Testing: Pass Fail NOTES
Operational (No Load)
Operational (100% Load)
Operational (Maximum Test Load*)
* Maximum test load should never exceed 125% of rated capacity.
This form may be photocopied and used as an inspection record.
4 Form 47099007 Edition 3