Ingersoll-Rand 359, Инструкция по эксплуатации

Страница: 2 / 38

2
WARNING LABEL IDENTIFICATION
FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
WARNING
Always wear hearing
protection when operating
this tool.
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Do not carry the tool by the
hose.
WARNING WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
WARNING
Operate at 90 psig (6.2 bar/
620 kPa) Maximum air pres-
sure.
90 psig
(6.2bar/620 kPa)
International Warning Label:
Order Part No. ___________
SANDER SPECIFIC WARNINGS
FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
•
These Sanders will operate at the free speed
specified on the nameplate if the air supply line
furnishes 90 psig (6.2 bar/620 kPa) air pressure at
the tool. Operation at higher air pressure will
result in excessive speed.
•
Use only a sanding pad, buffing wheel or polishing
bonnet with these tools. Do not use any grinding
wheel, bur or metal removing accessory other than
a sanding pad with these tools. Never use an
accessory having a maximum operating speed less
than the free speed of the Sander in which it is
being used.
PLACING TOOL IN SERVICE
LUBRICATION
Ingersoll–Rand No. 50 Ingersoll–Rand No. 68
Always use an air line lubricator with this Sander.
Filter–Lubricator–Regulator Unit.
For International – C28–C4–FKG0
For USA – C28–04–FKG0–28
After each two hours of operation, if an air line
lubricator is not used, inject 0.5 to 1 cc of oil into (9).
After every 160 hours of operation, flush the tool with a
solution of three parts cleaning solvent to one part oil.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
FILTER
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
COMPRESSOR
(Dwg. TPD905–1)
SPECIFICATIONS
Model Pad Size Free
Speed
H
Sound Level
dB (A)
♦
Vibrations
Level
in (mm) rpm Pressure Power m/s
2
359, 359–EU 3–2/3 x 9 (93 x 228) 8,000 78.4 ––– 9.2
H
Tested in accordance with ANSI S5.1–1971 sanding on steel workpiece
♦
Tested in accordance with ISO8662–1 sanding on steel workpiece