4–4
FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
USING THE TOOL (Continued)
•
Do not remove the Inlet Plug without first
disconnecting the live air supply.
•
Whenever the Angle Head is installed or
repositioned, the Throttle Lever must be
positioned so that reaction torque will not tend to
retain the throttle in the “ON” position.
•
When installing or removing the output device on
any tool, ALWAYS grasp a metal component of the
tool while tightening or loosening the Coupling Nut
or Spindle Cap. Acceptable clamping
locations include, but are not limited to, the hex on
the Gear Case, the Tool Hanger, the Torque
Reaction Arm or any metal Mounting Plate.
NEVER grasp the composite tool body or handle in
vise jaws to restrain the torque of the Coupling Nut
or Spindle Cap. Such practice will result in
damage to the tool.
•
Do not use power units and gear trains that exceed
the capability of the output device.
•
The Tube Nut Attachment has an opening on the
front side for construction and application
purposes. DO NOT, under any circumstance place
your fingers in this opening.
•
The Torque Reaction Bar must be positioned
against a positive stop. Do not use the Bar as a
dead handle and take all precautions to make
certain the operator’s hand cannot be pinched
between the Bar and a solid object.
•
When operated continuously for long periods of
time, Series D Nutrunners may become hot at the
spindle end of the tool. Take all precautions
necessary to avoid skin contact with the hot
surfaces. Prolonged contact may result in burns.
•
All Series D Torque Control Wrenches and
Nutrunners with reverse capability have rotational
arrows molded into the housing in the area of the
reversing mechanism. When the direction
switching device is positioned nearest the molded
circular arrow with an “F” in the center, spindle
rotation will be forward or clockwise direction.
When the direction switching device is positioned
nearest the molded circular arrow with an “R” in
the center, spindle rotation will be reverse or
counterclockwise direction.
WARNING LABEL IDENTIFICATION
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
WARNING
Always wear hearing
protection when operating
this tool.
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Do not carry the tool by the
hose.
WARNING
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
WARNING
Operate at 90 psig (6.2 bar/
620 kPa) Maximum air pres-
sure.
90 psig
(6.2bar/620 kPa)
WARNING
The Torque Reaction Bar must
be positioned against a
positive stop. Do not use the
Bar as a dead handle and take
all precautions to make certain
the operator’s hand cannot be
pinched between the Bar and
a solid object.
Содержание 150 D Series
Страница 6: ...4 6 Dwg TPA1724 ...
