Ingenico IUC150B, Руководство по интеграции, Страница: 6 / 23

6
ETHERNET
• The iUP250 PINPad unit can be connected to Ethernet.
The connector type is shielded RJ45.
• The Ethernet cable is standard and not provided.
• The Ethernet cable must be shielded.
USB DEVICE
The iUP250LE unit can be connected by a JST low profile
connector.
USB HOST
The iUP250LE unit can drive 3 USB accessories. The connector
are standard type A (x2) and 1 JST low profile connector.
The power available is limited to 1.5 A Max dispatched between
the 3 USB.
PIN SHIELD LIGHT OUTPUT
PIN No Function
Pin 1 (center)
1 5 V
2 HZ Light off
“0” Light on
RGB BACKLIGHT
The iUP250LE has a RGB backlight controlled by applications.
Red backlight is used to indicate the following priority
information:
• Red backlight on steady: product has been tampered
(Key erased, irruption).
• Red backlight fl ashing slowly: product is disabled
(Keys erased, no irruption).
• Red backlight fl ashing quickly: product is out of order
(Commissioning needed).
The iUP250LE has a maintenance button on the back.
• To enter LLT mode, press the button at power up or at
restart, until the red led lights on.
• To enter Maintenance mode, press the button at power
up or at restart, until the red led starts blinking.
• To restart the product, press the button until the blue led
lights on.
BUZZER
The buzzer is controlled by the application. The frequency
depends on the software.
The iUP250LE PIN pad unit can be connected to a serial port.
The connector type JST.
PIN No Function
1 GND
2 Wake-up
3 RXD
4 TXD
5 CTS
6 RTS