Getting Started
Customer cards must be inserted as shown, with the
chip upwards. Push the card fully into the slot below
the keypad and follow the instructions on screen.
If you see a BAD READ message, check the card
orientation and try again. After three bad reads
the terminal will prompt you to swipe the card.
DO NOT remove the card until instructed to do so
by the terminal.
Quick Start Guide - Ingenico EFTBEMi
Set up the terminal in a convenient location.
Plug the power supply unit into the power
socket, and the phone lead into the socket
on the base unit. Press the key once to turn on
the terminal.
After a short initialisation process the main idle screen
will be displayed, the terminal now ready to use.
NB: Press and hold the yellow key and the key
together to turn the terminal off .
2
4
5
3
1
1
01483
SUPERVISOR PASSWORD:
The default Supervisor Password is 01483.
NB: You should change this password.
F1-F4 Keys:
These four function keys enable you
to choose the options on screen and correspond to
the to labels displayed on screen.
MENU Key:
To enter the application menus press
the key from the idle screen. Pressing the key
again moves to the next menu (if available).
Correction Keys:
When entering numbers or letters,
the yellow key deletes one character at a time,
while the red key deletes the entire line. The
key also cancels transactions.
OK Key:
The green key is used to confi rm anything
that has been typed into the terminal.
Power/Feed Key:
To test the feeding of the paper
through the printer press the key.
See page 4
for instructions to change the paper rolls.
3
4
5
2
1
The Chip Card Reader
