11/32" OUTSIDE NUT
11/32" INSIDE NUT
(SNUG TO CERAMIC)
5
REPLACEMENT ELEMENT INSTALLATION
(VISIT INFRATECH-USA.COM FOR VIDEO INSTRUCTIONS)
Disconnect the power at the breaker. Remove the grill by grasping it in the middle, flex grill up and lift it off. Unscrew
and remove both end reflectors. Unhook element clips at each end of the heater and remove nuts from end of element
to remove the existing quartz tube. Carefully install the new element. Remove one nut from end of the new element.
Install wire by sliding high temperature ring terminal onto element screw and replace nut. Use a thin 11/32" wrench to
hold inside nut. Nuts must make a tight connection. Close element clips over tube, reinstall end reflectors, then snap
protective grill back in place.
NOTE: Hold ceramic element firmly while
tightening nut to prevent damage to
element. Nut should be tightened snug.
A loose connection can cause the
element to short or fail prematurely.
Need help?
To order replacement
elements for your Infratech
heating system.
Consult the label on back of
heater for proper watts, voltage,
and replacement element part
number.
REPLACEMENT ELEMENTS
(OTHER VOLTAGES ALSO AVAILABLE)
PART NUMBER
ELEMENT NUMBER
LENGTH
WATTS
VOLTS
FITS
10-1020
E-7512
16-1/2"
(0.4m)
750
120
W-7512
10-1050
E-1412
30" (0.8m)
1500
120
W-1512
10-1055
E-1424
30" (0.8m)
1500
240
W-1524/WD-3024
10-1085
E-2024
36" (0.9m)
2000
240
W-2024/WD-4024
10-2010
E-2524
36" (0.9m)
2500
240
W-2524/WD-5024
10-2030
E-3024
58" (1.5m)
3000
240
W-3024/WD-6024
10-2055
E-4024
58" (1.5m)
4000
240
W-4024
REPLACEMENT PARTS
PART NUMBER
PART DESCRIPTION
QUANTITY
13-1210
Single Element End Reflector (Set of 2)
1
13-1252
Dual Element End Reflector (Set of 2)
1
13-1202, 13-1200, 13-1205
Body Reflector – Fits 33" (0.8m), 39" (1.0m), 61-1/4" (1.6m)
1
13-1242, 13-1240, 13-1245
Grill Guard – Fits 33" (0.8m), 39" (1.0m), 61-1/4" (1.6m)
1
13-1232, 13-1230, 13-1235
Lead Wire Set – Fits 33" (0.8m), 39" (1.0m), 61-1/4" (1.6m)*
1
22-1151
SS Mounting Bracket (Set of 2)
1
18-2295, 18-2300, 18-2305
Flush Mount SS Plaster Frame – Fits 33" (0.8m), 39" (1.0m), 61-1/4" (1.6m)
1
* Note: Dual Element Heaters require 2 Lead Wire Sets per Heater
