31
INFOSEC UPS SYSTEM – 15, Rue du Moulin – 44880 Sautron – France – www.infosec-ups.com
Hot Line Tel : +33 (0)2 40 76 15 82 – fax : +33(0)2 40 94 29 51 – [email protected] –
03 17 AA 59 204 10
Terminal Block wiring diagram of E4 LCD Pro 5K(S)/6K(S)/8K(S)/10K(S)
NOTE 1:
Make sure that the wires are firmly connected to the terminals.
NOTE 2:
Please install the output breaker between the output terminal and the load, and the circuit breaker
should be qualified with a current leakage protective function if necessary.
6)
Put the terminal block cover back on the rear panel of the UPS.
2-4. Software Installation
For optimal computer system protection, install the UPS monitoring software to fully configure UPS
shutdown.
Communication ports:
USB port RS-232 port Intelligent slot
To allow for unattended UPS shutdown/start-up and status monitoring, connect one end of the
communication cable to the USB/RS-232 port and the other to the communication port of your PC. With the
monitoring software installed, you can schedule UPS shutdown/start-up and monitor UPS status on your
PC.
The UPS is equipped with an intelligent slot, ideal for either an SNMP or AS400 card. When installing either
an SNMP or AS400 card in the UPS, it will provide advanced communication and monitoring options.
Note: A USB port and RS-232 port cannot work at the same time.
Input Neutral
Input Line
Ground
Output Line
Output Neutral
