2. Fix the heater assembly to the brackets
via the hole in the centre of the joining
bar. The joining bars should slide inside
the gap of the two wall brackets.
3. Place a bolt and washer in the hole of
the wall bracket and put a serrated
washer on the opposite side between
the bracket and joining bar. Repeat on
opposite side.
1. Securely fasten the L-shaped wall brackets to the mounting surface using both of the fixing
holes in the short part of the bracket (see Fig. H for mounting hole template centres).
Please refer to Table 1 for recommended positioning of the heater. Please note. wall
fixings are not supplied. They should be selected to substantially support the weight of the
installation. If in doubt contact a professional for advice!
When two Alpha H1 heaters are joined they can also
be chain hung from a ceiling (Fig. J).
Please refer to Table 1 for the recommended
positioning of the heater with regards to minimum
distances. Do not install the heater in a corner!
Always allow the heater to cool before attempting to
reposition/move. Never attempt to move the heater
while it is switched on!
continued on next page…
Fig. H
DRILLING HOLE TEMPLATE DIMENSIONS
FOR WALL MOUNTED BRACKETS
C H A I N H A N G I N G - T W O S I N G L E H E AT E R S J O I N E D
Fig. J
S
E
E
T
A
B
L
E
1
F
O
R
M
IN
IM
U
M
D
IM
E
N
S
IO
N
S
9
4. Fit the heater assembly to the brackets and place a washer and nut on the bolts
protruding through the joining bars.
5. Fully tighten the nut and bolts (Fig. G) with the heaters set as shown in Fig. F.
6. Secure the supply cables so they do not rest on the body or obstruct air-vents.
Always isolate the heater from the mains supply when adjusting the angular position.
C A U T I O N
C A U T I O N
C A U T I O N
C A U T I O N
Switch off/unplug the heater from the mains supply
when mounting or adjusting the heater position.
