Infomir MAG-00, Руководство пользователя

Страница: 15 / 50

MAG-200. User Guide (Rev 1.2 05/02/2010,17:23)
Basic software loading
To be able to perform its functions the device must be loaded with its software (basic
software). The basic software can be loaded either from internal flash-memory of the device
or through the local network. The basic software loading stages are indicated on the TV
screen and on the front panel indicator.
Loading from internal flash-memory of the device (“NAND”)
The loading of the basic software from the NAND memory can be used for off-line playing of
multi-media content. Such content may be located on the external flash-memory connected
through USB port (not to be confused with internal NAND flash-memory of the device) or on a
home media UPnP server.
The basic software image stored in the NAND memory is initially recorded there by the
manufacturer. This image can be re-recorded and easily replaced by a new one in case of
issuing a new version of the software.
To load basic software from the NAND set the parameter «Boot Mode» in the bootstrap
loader to the value «NAND», and exit saving the data. For this purpose proceed as follows:
1) Make sure that the device is correctly connected to the TV and the video input on the
TV set is correctly chosen
2) Enter the bootstrap loader menu (with the device switched off press and keep for
several seconds the remote control button «menu» until blue screen with the menu
appears).
3) Using remote control button
« »
move to the item
«
boot mode
»
and using
« »
set its
value to «NAND»
4) Move to the menu item «Exit & Save»
5) Press the button
« ».
The message «Please confirm save change. Press OK», will
appear on the screen, suggesting to press
«
OK» button to confirm saving the changes
6) Press «OK» button
As the result the message «Saving…» (saving the data), then «OK. Reboot…» will appear on
the screen. If the mode of loading from NAND is switched on, the indication «Load from
nand» appears at the bottom of the screen immediately after reloading.
Loading from local network (“DHCP”)
The loading of the basic software through the local network is advantageous because in case
of issuing a new version of the software it makes much easier the process of updating the
image stored in the NAND memory of each device on the network.
To load basic software through the local network set the parameter «Boot Mode» in the
bootstrap loader to the value «DHCP» and exit with saving the data. Proceed as follows:
1) Make sure that STB is correctly connected to the TV and correct video input is chosen
on the TV set
2) Make sure that Ethernet-cable is connected to the «LAN» connector on the rear panel
of the device (connector RJ-45)
15