14
15
Press “GO” (for about 1 second) on the self-charging base, and you will see
Battery, Brush and GO icons turned on (as shown below) on the left side of LCD
panel. This indicates that the QQ2 LT vacuum will automatically start a cleaning
cycle right after the battery is fully charged.
Press the “GO” button again to turn this function off.
Note: QQ2 LT vacuum
cleaner will only run one cleaning cycle after “GO” button is selected.
If you hold down “GO” button for 5 seconds, the QQ2 LT on the self-charging
base will leave the base and begin the cleaning right away, no matter whether
the battery has been charged in full or not. This function works the same way
as you push “START” button on the remote control on page 7.
When the QQ2 LT is being charging on the self-charging base, you can direct the
QQ2 LT to begin cleaning when you press “START” button on your remote
control.
QQ2 LT Series
QQ2 LT Series
QQ2 LT Series
Operations
Roller Brush Installation and Removal
Ensure that the power of the CleanMate is 'Off', and turn the CleanMate upside
down so that the bottom of the unit is facing you.
Align the slotted end of the roller brush with the slot in the flexible insert in
the right side of the roller brush compartment (near the side brush) and press it
into place.
Push the free end of the roller brush down into the roller brush compartment,
and align the free end with the brush holder on the left side of the
compartment. Slide the roller brush to the left to secure it in place.
Illustration 4
Illustration 3
Illustration 2
Illustration 1
