Instructions:
1. This CleanMate Sonic Wall is powered by 2 AA batteries. Make sure to
install the included AA rechargeable batteries in correct polarity.
2. To turn on the Sonic Wall, slide the power switch to position "1".
3. For best effect, put the Sonic Wall on the other side of the door (see picture
below) when you want to confine it in certain area. The CleanMate unit will
detect the ultrasonic barrier from the Sonic Wall and not cross the invisible
barrier line.
4. The effective distance of the Sonic Wall barrier is about 10 ft long.
5. To turn off the Sonic Wall, slide the power switch to position "0" to save
battery power.
6. The LED power indicator on Sonic Wall will start blinking when its battery
power is low. User can charge the Sonic Wall battery using the same
CleanMate charger (item No. 5 on page 4) by plugging it into the charging
socket on Sonic Wall.
Power switch should be at ON position during battery charging and green
LED light will be blinking. Green LED light will be steady after charging is
complete.
1
2
Press the "Mode" button again (6 times) to return to "Automatic"
mode (all 5 cleaning patterns). The Timer display will show "A" for one
minute.
6.UV Button: Allows you to turn On and Off the ultraviolet light as needed.
7.Vacuum Motor Off Button: Press this button to control the On/Off of the
vacuum motor.
8. Home Button: Use this Button to make QQ2 LT go back to the
charging base.
9. Power Off Button: to power Off QQ2 LT manually by pressing
power Off Button.
Sonic Transmitter
Sonic Transmitter
Charging Socket
Power Switch
LED Power
indicator
The Sonic Wall only works with
CleanMates that have the Sonic Wall
Sensor on their bumper
(refer to diagram on page 5)
.
It will create an
invisible barrier that the CleanMate will not cross. This way, users can easily
confine the CleanMate to one room or certain area to improve cleaning
efficiency.
When CleanMate detects the ultrasonic signals from
Sonic Wall, it will turn around and head to another
direction.
QQ2 LT Series
QQ2 LTV
QQ2 LT Series
Sonic Wall Setup
1. Use two hand fingers to press the tabs at the front of the battery cover.
Lift up the battery cover by these tabs as shown in Illustration 1.
2. Make sure the battery is inserted in the correct orientation by aligning
the silver strips on the battery with the metal tabs in the battery
compartment. Battery lifting band should face up after battery is
installed. See Illustration 2.
3. Close the battery cover by first inserting the tabs into the slots at the
back of the unit, and then pressing down on the front side of the battery
cover until the plastic tabs click in place. Please see Illustration 3.
