CleanMate 365
CleanMate 365
CleanMate 365
CleanMate 365
Illustration 1
Illustration 2
Illustration 3
Illustration 4
1.Make sure you have completely charged the unit before using it for the
first time.
2.Room preparation:
A.Pick up all large items off of the floor that could get stuck in the brushes
or the vacuum intake.
B.Pick up/hide all cords that could get tangled in the unit.
C.Move all items that could be easily knocked over.
D.Roll under loose edges of rugs with any type of stringy fringe.
3.DO NOT use the QQ-2 on plush or long pile carpet or rugs.
CleanMate 365
CleanMate 365
4.When using the QQ-2 in a room for the first time, watch how it operates
in the room. Watch for areas that the unit has troubles operating in, and
either block these areas of the room or move objects around so that the
unit can clean effectively and not get stuck or hung up before it has had an
opportunity to clean the entire room.
Starting Operation
1.Clean out the dust bin before use.
2.Place the QQ-2 on the floor in a relatively open space near the middle of the
room to be cleaned.
3.Flip the power switch of the unit to 'On'.
4.Set the timer of the unit to the desired cleaning time by pressing the Timer
button on the control panel of the unit or on the remote control.
For Reference: Use 10 minutes of cleaning time for Every 54-72 square feet
of floor space. Cleaning time may vary depending on the type of floor being
cleaned.
5.Press the Start button on the control panel or the remote control. After a
short delay, the QQ-2 will begin to automatically clean the floor.
6.At the end of the cleaning cycle, the QQ-2 will emit a long beep and will
turn off the cleaning function and start to search for docking station.
If the low battery light on the unit is blinking, then the battery is low and
needs to be recharged before the unit can be used again.
Stopping Operation
1.Press the Start/Stop button on the control panel of the unit.
2.Press the Stop button on the remote control.
Cleaning and Maintenance
The operation and maintenance of the QQ-2 is very simple, but to maintain
proper performance of the unit, it is recommended that you follow a routine
cleaning and maintenance schedule.
1.Make sure to clean out the Dust Bin and to brush off the Air Filter after
every cleaning cycle.
2.Make sure that the vacuum intake is free of any obstructions.
3.Check to make sure that the bristles of the Side Brush are free and not tangled.
4.Make sure that there is not a lot of hair, string, etc caught up in the Rolling
Brush.
5.Remove and clean out the Rolling Brush.
6.Make sure that there is nothing obstructing the air ventilation slots on the
top of the unit.
CleanMate 365
CleanMate 365
Installing Basic Accessories
Installing Basic Accessories
General Operation
General Operation
General Operation
General Operation
Cleaning and Maintenance
Cleaning and Maintenance
12
13
