7
Input/Output Port
①
Pin Assignment
1
Audio In
2
Audio Out
3
Audio /Alarm GND
4
Audio/ Alarm GND
5
Alarm In 1
6
Alarm Out
7
Alarm In 2
8
Alarm Out Com
9
Power Input
(12VDC -/24VAC~)
10
Power Input
(12VDC +/24VAC~)
Notes: The analog video is closed when the MJPEG video stream is enabled.
To enable the analog video, please close the MJPEG video stream.
On the left of camera body (face the lens to view), there is an IRIS connector.
The pin definition is as follows:
Note: The camera supports DC DRIVE or VIDEO DRIVE. The factory default
setting is DC DRIVE.
1
2
3
4
Figure 2-2
⑥
Reset Button: The camera supports short press and extended press reset
modes. If press and hold the button from 2s to 15s (i.e. short press), Power
LED Indicator will turn green, and camera’s parameters will restore the
default values. If press and hold the button more than 15s (i.e. extended
press), Power LED Indicator will turn orange, and camera’s system will
resume factory default settings. Power LED Indicator will flicker quickly
while holding time is about 15s.
Note: if press Reset button, the IP address will become to 192.168.1.100.
Pin
VIDEO DRIVE
DC DRIVE
1
2
3
4
POWER input
IRIS input
N.C.
GND
DAMP-
DAMP+
DRIVE+
DRIVE-
