Infinova V1700N-NE2 Series, Руководство по установке

Страница: 17 / 24

11
Indoor mounting Outdoor mounting
Figure 3-34 Installing Housing
5. Take out the dome drive from the dome package. (Note:
dimisters are included in outdoor dome drive). The address ID
and baud rate can be set via either software or DIP switch. If
setup via DIP switch is selected, please refer to Appendix I.
6. Line up the two tabs located on the upper side of the dome drive
with the corresponding grooves in the housing. Insert both tabs
into the grooves. Push up the dome insert until both tabs click
into place. Be sure that you hear two clicks.
7. Take out the dome bubble from the dome package and fix the
safety cord. As one end of safety cord has already fixed to the
upper housing, and the other end should be tied to the dome
bubble. Line up the screw holes of the dome bubble with
corresponding holes on the housing, and then secure the cover
with supplied screws.
8. Turn on the power. The dome will pan, tilt, and zoom to initiate
system parameters as well as to verify the normal operation of
the dome drive.
After the initiation sequence, the dome will stop and be ready for
programming and operation.
Indoor mounting Outdoor mounting
Figure 3-35 Pendant mounting
Appendix I DIP Setting
The address ID and baud rate can be set via either software or DIP
switch. Whatever way users choose, there are 1~254 address ID
available for PELCO-P/D and INFINOVA protocol.
If setup via DIP switch is selected, refer to this section to make
relevant settings before installing the dome. Please note that
Address ID=Rx Address No. + 1 (off=0, on=1)
When the positions of S2 are all on “ON” status, the address and
baud rate can be set via software.
If users select setup via DIP switch, S2 is used to set address, while
S1 is used to set baud rate, protocol and terminal resistor
connection status. Refer to the figure below for the specific position
of switch S1 and S2.
Indoor Mounting Outdoor Mounting