Infinova V1700N-NE2 Series, Руководство по установке

Страница: 14 / 24

8
and secure it with eight expansion bolts. For dimensional
diagram of the bracket base, please refer to the following figure
(Unit: mm).
A
A view
2 thick
130
10
0
80
R3
135
°
16
0
12
0
60
8 7
Figure 3-22 Installing Bracket Base
2. Use the four screws supplied with the mount bracket to secure
the bracket onto the base.
Figure 3-23 Installing Mount Bracket
3. Take out the upper housing from the dome package. Pull the
system cables (power cable, network cable and etc.) through the
bracket and lead them out from the central hole on the base plate
of bracket.
4. Screw the upper housing onto the mount bracket. For outdoor
housing, it is recommended to apply thread compound to the
threads on the housing. Secure the connection with a holding
screw.
Holding Screw
Outdoor Mounting
Holding Screw
Indoor Mounting
Figure 3-24 Installing Housing
5. Take out the dome drive from the dome package. (Note:
dimisters are included in outdoor dome drive). The address ID
and baud rate can be set via either software or DIP switch. If
setup via DIP switch is selected, please refer to Appendix I.
6. Line up the two tabs located on the upper side of the dome drive
with the corresponding grooves in the housing. Insert both tabs
into the grooves. Push up the dome insert until both tabs click
into place. Be sure that you hear two clicks.
7.
Take out the dome bubble from the dome package and fix the
safety cord. As one end of safety cord has already fixed to the
upper housing, and the other end should be tied to the dome
bubble. Line up the screw holes of the dome bubble with
corresponding holes on the housing, and then secure the cover
with supplied screws.
8. Turn on the power. The dome will pan, tilt, and zoom to
initiate system parameters as well as to verify the normal operation
of the dome drive.
After the initiation sequence, the dome will stop and be ready for
programming and operation.
3.5 Pole Mounting
3.5.1 Indoor Mounting Specifications
Below figures show the Pole mounting specifications (Unit: mm):
Figure 3-25
3.5.2 Outdoor Mounting Specifications
Below figures show the Pole mounting specifications (Unit: mm):