US-1 Theater Pac – Owner’s Manual
◆
5
NOTE: The customer is responsible for
the correct selection and use of mounting
hardware (available through hardware
stores) that will ensure the proper and
safe wall-mounting of the speakers.
V
ERTICAL
M
OUNTING
...
Figure 4. This illustration shows how to
mount a US-1 speaker vertically on a wall
or ceiling four different ways.
W
ALL
-M
OUNTING THE
US-1
US-1 speakers can be wall- or ceiling-mounted, as shown in Figures 4 and 5. You can mount the
speakers with #6 wood screws (not included), using the built-in mounting bracket.
Use the enclosed template to mark the desired position of each US-1 on a wall or ceiling.
Locate a stud for secure mounting and use heavy-duty wood screws with long threads. Test
the mounting thoroughly before installation.
To mount the US-1 speaker vertically on a wall, fasten the wood screws (not included) to a
wall stud, leaving a 3⁄16" clearance between the base of the screw head and the wall. If desired,
loosen the bracket screw, adjust the bracket angle, and tighten the bracket screw.
NOTE: You may want to route the wires before tightening the bracket screw (see Figure 7 on page 7).
Then orient the speaker vertically, align the crossholes on the rear of the US-1 with the wood
screws, and slide the speaker down.
#6 Wood Screws
(fasten to wall stud)
US-1 VERTICAL MOUNTING USING BRACKET
Slide Speaker Down
Onto Wood Screws
US-1
(rear view)
Screw
(inside hole)
US-1 Positions
(top view)
45
°
From Wall
(Bracket Open,
Position #1)
20
°
From Wall
(Bracket Closed)
67.5
°
From Wall
(Bracket Open,
Position #2)
90
°
From Wall
(Bracket Open,
Position #3)
❶
Loosen Screw
❷
Rotate Bracket
❸
Tighten Screw
3/16"
wall
wood
screw
(side view)
INF1446 3/22/99 9:58 AM Page 5
