4
◆
US-1 Theater Pac – Owner’s Manual
V
ERTICAL
P
OSITION
...
Figure 2. This illustration shows how to
vertically position US-1 speakers
two ways.
H
ORIZONTAL
P
OSITION
...
Figure 3. This illustration shows how to
horizontally position US-1 speakers
three ways.
S
HELF
P
LACEMENT OF
US-1
US-1 speakers can be positioned vertically in two positions on a shelf or stand, as shown in
Figure 2. Set each US-1 flat, with the logo at the bottom and the bracket facing inward.
You can also push the speakers gently back for a 20° tilt.
US-1 speakers can be positioned horizontally in three positions on a shelf or stand, as shown
in Figure 3. Set each US-1 flat, or push the speakers gently back for a 20° tilt. Rotate the logo
to match the orientation of the speaker. To provide a 10° tilt-down angle, loosen the bracket
screw on the rear door with the hex wrench (included) and adjust the bracket to
Bracket Open,
Position #1
. Tighten the bracket screw when you have reached the desired angle.
NOTE: You may want to route the wires before tightening the bracket screw (see Figure 7 on page 7).
US-1 VERTICAL PLACEMENT ON A SHELF
Flat
Position
US-1
(side view)
US-1
(side view)
20
°
Tilt-Up
Position
US-1 HORIZONTAL PLACEMENT ON A SHELF
Flat Position
(Bracket Closed)
US-1
(rear view)
20
°
Tilt Up
(Bracket Closed)
10
°
Tilt Down
(Bracket Open,
Position #1)
US-1 Positions
(side view)
❶
Loosen Screw
❷
Rotate Bracket
❸
Tighten Screw
Screw
Bracket
INF1446 3/22/99 9:58 AM Page 4
