Infinity ISE-12ZWDN650 FD, Руководство по эксплуатации

Страница: 22 / 37

40 | ISE-12ZWDN650 FD ISE-12ZWDN650 FD | 41
ENG
CAMERA SETUPS AND CABLE CONNECTIONS
6. CAMERA SETUPS AND CABLE CONNECTIONS
Before installing or connecting the Dome Camera, please refer to this section and complete preparation, switch
setting and communication switch settings.
Before connecting the Dome Camera to other devices of CCTV system, please complete the Dome Camera’s ID
and communication switch setting. These switches are located on the bottom of the Dome Camera. Additionally, the
22-Pin Connector for Data Cable connection and ISP Connector for firmware upgrade kit connection are located on
the back plate of both analog and network Speed Dome Cameras.
Please refer to the diagrams and tables accompanied with for use of each switch/connector.
6.1
DOME CAMERA SETUPS
6.1.1
SWITCH DEFINITION
A Camera Control Protocol Switch
B Communication Switch
C None
D 22-Pin Connector
E ID Switch
F Reserved
G ISP Connector (for FW upgrade)
The ID and Protocol numbers of an analog camera are set with a 10-bit and 6-bit dip switch respectively using binary
system.
Note: No two Dome Cameras should be given the same ID, or communication conflict may occur.
The analog Dome Camera’s communication switches are specified in the table below.
6.1.2
COMMUNICATION SWITCH SETTING
Communication Switch SW1 RS-485 Setting
SW2
SW3 Termination
SW4 Line Lock
SW5 Factory Default Reset
SW6 Camera Upgrade
CAMERA SETUPS AND CABLE CONNECTIONS
RS-485 is the interface that communicates the Dome Camera and its control device; for this reason, the RS-485
setup of the Dome Camera and the control device must be the same. The RS-485 default setting is half-duplex (see
the diagram follows). Please do not change the default setting without qualified specialist or supplier’s notice. As for
the SW 3 and SW 4, they are used for termination and Line Lock adjustment respectively. The SW 5 is mainly used
when users want to restore the camera to the factory default status; moreover, once firmware upgrade is carried out,
users need to reset the SW 6 afterward.
RS-485 Setting
Half-duplex Full-duplex
Please change the analog Dome Camera’s ID if there is more than one Dome Camera in the same network. Use the
switch to change your Speed Dome Camera’s ID by setting the 10-bit dip switch. For instance, if the camera’s ID is
006, set the SW 8 and SW 9 to “ON,” with the rest to “OFF,” as shown below.
6.1.3
ID Setup
Define the protocol you are going to use basing on the devices of your surveillance system. Generally, use one
protocol even the devices are provided from different manufacturers. Please refer to the table below for all supported
protocols with their matching switch numbers and baud rate and choose a protocol for your Speed Dome Camera.
6.1.4
CAMERA CONTROL PROTOCOL SETUP