Infinity iB-5R, Руководство пользователя

Страница: 9 / 36

8
Ordercode: 41530
Infinity iB-5R
Overview Backside
Fig. 01 Fig. 02
01)
Lens
02) LCD display
03) DMX signal connector (IN) 5-pin
04) DMX signal connector (OUT) 5-pin
05) DMX signal connector (IN) 3-pin
06) DMX signal connector (OUT) 3-pin
07) Neutrik Powercon IN
08) Fuse F7AL/250V
09) Power switch ON/OFF
10) Ground/earth connection
NOTE: Knowledge of DMX is required to fully utilize this unit.
Installation
Remove all packing materials from the Infinity iB-5R. Check that all foam and plastic padding is removed.
Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Installing the Lamp
The Infinity iB-5R uses the Osram Sirius HRI 230W (ordercode 81014) bulb as manufactured by all popular
manufacturers. Use only the appropriate lamp for your unit.
Note that, product versions that use other lamps, may be offered in the future. Check your product
specification label for information.
Always disconnect from electric mains power supply before changing lamps.
The lamp has to be replaced when it is damaged or deformed due to the heat.
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the
device was not designed for.
Damages caused by non-observance are not subject to warranty.
Always read the safety instructions that are included with the lamp.
Oil on hands shortens the lamp life. (If you touch the bulb glass, wipe off the glass with a clean,lint-free
towel and rubbing alcohol.).
Always read all the safety warnings at the beginning of this manual, before replacing the lamp!!!
Let the lamp cool down for 20 minutes, before replacing the lamp.