Installing the Blades:
1.
Insert the fan blades into the slot and secure using 3 blade screws and washers provided as shown in Figure 12.
Figure 12 – Installing the Blades
Hanging the Fan:
1.
Raise the fan and place the ball joint into the mounting bracket slot. Make sure that the guide pin of the bracket is fitted into
the corresponding slot of the ball joint. You should feel the guide pin setting into the slot of the ball joint.
Refer to Figure 13
Figure 13 – Hanging the Fan
Wiring the Fan:
1.
Disconnect the power by turning off the circuit breakers to the outlet box and associated wall switch location.
2.
This DC Ceiling Fan is designed to be controlled by the 6 Speed Remote Control included. Refer to Figure 14 for wiring
instructions.
a.
The terminal (green wire) block shown in graphic is pre-installed on the mounting bracket
b.
Wire colors from house may vary in color and may not include the ground wire (green), so please ensure that all
wiring is secure and to code. After wiring is completed, gently push wires into the junction box with the terminal
blocks upward.
c.
Do not cut the gray sensor wire in any situation.
9