Troubleshooting the Remote & Receiver Pairing
Should the remote and receiver lose control after installation or during use, the pairing of the remote and the receiver must be repaired.
Below are the operating symptoms and method to repair the pairing of the DC ceiling fan remote and receiver.
Issues
:
•
Loss of control - Fan only running at high speed after installation
•
Loss of control - No reverse function after installation
•
Loss of control - remote cannot communicate with receiver
Solution:
If the fan runs at the highest speed continuously, it means the wiring of the installation is correct. When the fan is operated on high
speed only, or fails to operate in reverse function or any other command/s, it is recommended to repair the communication pairing of the
remote and receiver. Please follow the steps below:
A.
Remove the battery cover of remote, make sure the battery is installed correctly and the red LED light indicator
will be flashing, it means the remote function is okay.
B.
Turn off the main supply to receiver more than 30 seconds and turn on the main supply to receiver again. Press
and hold the SET button of
remote
for 6 seconds within 60 seconds of turning turn the power to the receiver.
C.
Press the buttons on the remote to run the fan. In general, performing point A, B, and C should repair the remote
and receiver, and will allow full control of the fan. If not, please kindly do the next step.
D.
The DIP switches of fans are set up at the factory in all up. And we can change DIP switch at any location in 16
options. (Ex. up-up-down-down).
E.
Please repeat the (A) ~ (C) steps to check the function.
If the issues still persist after following point (A) to (D), and there is still no control, then please refer to the Infinite
Breeze warranty hotline number or contact the nearest outlet for a new remote or transmitter.
Troubleshooting
14