Threaded components may work themselves slightly loose or blade brackets even bend slightly due to vigorous cleaning or bumping,
which may result in extra wobble and noise. Normal wear and tear is not covered under this warranty, but a little care and maintenance
can reduce or prevent this problem.
•
The fan must be installed so that the blades are more than 7 feet above the floor.
•
Ensure that all wiring is compliant with US National and Local Codes and ANSI/NFPI 70 regulations.
Always check the “Trouble Shooting Checklist” included in this booklet before calling for service. Unnecessary calls are inconvenient
for all and can attract a service charge.
For your safety, ensure the ceiling fan is OFF before carrying out any troubleshooting.
TROUBLE
PROBABLE CAUSES
SUGGESTED REMEDY
1. Fan will not start
Warning: The breaker must be
switched OFF,
and the assistance of a licensed
electrician
may be required.
A. Fuse or circuit breaker blown.
Check main and branch circuit fuses or circuit
breakers.
B. Loose power connections to the fan.
(Normally occurs during installation)
Check power connections to fan.
C. No response from the remote
transmitter
Battery is low. Replace batteries.
Check if correct remote transmitter is paired with
the receiver.
D. Switch the Fan ON via the mains
switch.
Check if there is power to the fan.
2. Fan Wobble
(Refer to Wobble section of the
manual for further information.)
A. Fan blades are not horizontal to
ceiling.
The blade may require adjustment at the blade
mounting screws;
The blade is out of shape, thus causing wobbling.
New blades set will be required to be replaced.
Contact retailer for further details.
B. Blade screws are loose.
Make sure all screws are securely fastened.
Warning
Normal Wear & Tear
Troubleshooting Checklist
17