Infineon CY7110, Руководство пользователя

Страница: 46 / 67

User Guide 46 of 67 002-32601 Rev. *C
2021-12-02
EZ- PD™ PMG1 MCU prototyping kits guide
CY7110/CY7111/CY7112/CY7113
Application development on CY711x kits using ModusToolbox™ software
Figure 38
Selecting the application
ModusToolbox ™ software downloads the resources required from GitHub for creating the project and
automatically closes the project creator window when the project creation is completed.
Note: Ensure that the PC is connected to the internet to access the GitHub repository.
See the application note [5] to learn more about the procedure to create new or modify existing applications,
the procedure to configure applications, and the procedure to build applications.
5.3 Programming and debugging using the KitProg3 interface
5.3.1 Programming using ModusToolbox™ software
KitProg3 is a PSoC ™ 5LP MCU-based onboard programming and debugging solution integrated with the EZ-
PD™ PMG1 MCU prototyping kits. You can program and debug the kit without using any separate programming
and debug module by setting the power selection jumper to short pins 2 and 3 and then connecting the kit to
the PC using the programming connecter as shown in
Figure 39 .
KitProg3 supports two modes for acquiring the device for programming/debugging:
•
Power cycle mode : In the CY7110 EZ-PD ™ PMG1-S0 MCU prototyping kit, KitProg3 acquires the device by
toggling the target (EZ- PD™ PMG1-S0 MCU) power in a sequence.
•
Reset mode : In all other kits, KitProg3 acquires the device by controlling the reset signal to the target MCU
(EZ- PD™ PMG1 MCU)