User Guide
47 of 67
002-32601 Rev. *C
2021-12-02
EZ-
PD™ PMG1 MCU prototyping kits guide
CY7110/CY7111/CY7112/CY7113
Application development on CY711x kits using ModusToolbox™ software
The KitProg3 programmer chooses the acquisition mode depending on the target MCU and prototyping kit.
Figure 39
Programming through the KitProg3 interface
Do the following to program the prototyping kit using the KitProg3 interface from the ModusToolbox
™
software:
1.
Open the Eclipse IDE for ModusToolbox
™ software
on the host PC. For details, see the Eclipse IDE for
ModusToolbox™ software
user guide
2.
Connect the power section jumper (J5) to position 2-3 (VIN).
3.
Connect the kit to the host PC through KitProg3 USB Type-C port (J1).
4.
Ensure that LED1 and LED2 glow amber.
LED2 (KitProg3 Power LED) indicates that the KitProg3 module and target MCU are powered. LED1 (status
LED) indicates the programming mode and status and is ON when KitProg3 is powered.
