Inficon BPG402-S, Руководство по эксплуатации

Страница: 17 / 54

tina46e1-b (2017-12) BPG402.om
17
If the gauge is used with an INFICON VGC40x / VGC50x controller, a correspond-
ing sensor cable is required (
→
[4]). The sensor cable permits supplying the gauge
with power, transmitting measurement values and gauge statuses, and making pa-
rameter settings.
Caution
Caution: data transmission errors
If the gauge is operated with the INFICON VGC40x / VGC50x Vacuum
Gauge Controller (RS232C) and a fieldbus interface at the same time,
data transmission errors may occur.
The gauge must not be operated with an INFICON VGC40x / VGC50x
controller and DeviceNet, EtherCAT or Profibus at the same time.
• Sensor cable ( →

[4]), INFICON sales literature)

Plug the sensor connector into the gauge and secure it with the locking
screws.

Connect the other end of the sensor cable to the INFICON controller and
secure it.
The gauge can also be operated with other controllers.
Especially the fieldbus versions BPG402-SD (DeviceNet), BPG402-SE (EtherCAT)
and BPG402-SP (Profibus) are usually operated as part of a network, controlled by
a master or bus controller. In such cases, the control system has to be operated
with the appropriate software and communication protocol (
→
 [1], [2], [3]).
3.2 Electrical Connection
3.2.1 Use With INFICON
VGC40x / VGC50x
Vacuum Gauge
Controller
Required material
Procedure
3.2.2 Use With Other
Controllers