C-COM Satellite Systems Inc.
Page 37 of 47
iNetVu
®
Fly-1201 User Manual
4) Set the Controller to the same network as the PC and VSAT Modem.
*
Note:
The controller IP should be set in the controller through the LCD
interface prior to entering it into the software tool for proper PC to Controller
Communication through network interface. (
USB Interface users may skip
this step)
To Configure the IP address on the controller, you must navigate to the
CONFIG menu using the LCD Interface. (config menu access password =
“password” by default)
a. Navigate to the “IP” menu and press the “ENTER” button.
b. Press the ‘↑’ button to allow for modification on the C_IP field
and set the IP address of the controller.
If router/modem IP is A.B.C.D, controller IP could be
A.B.C.D+1. Press the “ENTER” button once the change is
complete. For example, if the Modem/Router IP is 192.168.0.1
then the controller IP could be set to 192.168.0.2.
c. Press the “Exit” button twice to exit out of the configuration
menu. When prompted if you would like to save configuration,
press the ‘↑’ button to select “Y” (yes), and press “Enter”.
7000 IP:
A.B.C.D+1
Subnet Mask:
255.255.255.X (Modem/Router Dependent)
Gateway:
A.B.C.D (Router/Modem IP)
d. Click the “reset” button on the controller.
5) Run the iNetVu
®
7000 Mobile Software from the shortcut located on the desktop.
Advance to the “Configuration” screen, by right clicking on the “Controls” screen,
and selecting “Configuration”, and enter the controller IP address in the “IP
Address” section as depicted in the figure below.
USB users
may skip this step
.
