INELCO GRINDERS A/S AutoGrind
Inelco Grinders A/S, Industrivej 3, DK-9690 Fjerritslev, Denmark 5/8
E-mail: [email protected] , www.inelco-grinders.com
*List of cables pos. 3
**List of cables pos. 4
Male plug type
Part. No.
Female plug type
Part. No.
EU 230V-50Hz
74250014
EU 230V-50Hz
74300014
UK 110V-50Hz
74250015
UK 110V-50Hz
74300015
UK 220V-50Hz
74250016
UK 220V-50Hz
74300016
US 120V-60Hz /switch
75550015
US 120V-60Hz
74300017
3.
Mounting on the Ultima-Tig/Ultima-Tig-Cut
The original tightening screw and the stretching screw on the Ultima-Tig/-Cut
must be removed, which can only be done when the angle adjustment is in 90°
position. Otherwise it will fall down inside the grinding chamber.
The included stretching screw (Item No. 44550022) must be mounted in the angle
adjustment unit, using a little bit of white grease on the thread, and firmly
tightened with a 14 mm wrench. The included tightening screw (Item No.
75550019) is mounted loosely on the stretching screw. Then the desired grinding
angle is chosen and the tightening screw is tightened firmly by hand.
The AutoGrind grinding module can now be mounted on the tightening screw,
and secured by tightening the hexagon screw (x). Tool is included.
We recommend to position the grinding module, so that the cable from the
grinding module is hanging down to the right as shown on the front page picture
of this manual.
4.
Setting the grinding angle
By turning the grinding module counter clockwise, the angle adjustment is loosened and the angle can be
adjusted. By turning the grinding module clockwise, the angle adjustment is tightened again.
5.
Connecting AutoGrind and the grinder
The cable from the grinding module is connected to the control box.
The included short cable is connecting the grinder with the control box, so
that the mail IEC plug is plugged in the control box and the female plug is
connected to the male plug from the mains cable on the grinder
X
