1.
R eversing switch lever
CAUTION:
A lways check the direction of
rotation before operation.
CAUTION:
U se the reversing switch only after
the tool comes to a complete stop.
C hanging the
direction of rotation before the tool stops may dam-
age the tool.
CAUTION:
W
hen not operating the tool,
always set the reversing switch lever to the neu-
tral position.
This tool has a reversing switch to change the direction
of rotation. D epress the reversing switch lever from the
A side for clockwise rotation or from the B side for coun-
terclockwise rotation.
W
hen the reversing switch lever is in the neutral posi-
tion, the switch trigger cannot be pulled.
1.
Hard
2.
Soft
3 .
B utton
Y ou can change the impact force in three steps: hard,
soft.
This allows a tightening suitable to the work.
E very time the button is pressed, the number of blows
changes in two steps.
C hanging the impact force
1
2
3
H igh
Low
Change
only when
running !
Only Clockwise !
H igh
Low
Change
only when
running !
Only Clockwise !
Reversing switch action
►
1.
B utton
H igh
Low
Change
only when
running !
Only Clockwise !
1
,PSDFWIRUFHJUDGHGLVSOD\HG
RQSDQHO
0D[LPXPEORZV
3XUSRVH
([DPSOHRIDSSOLFDWLRQ
High
3, 300 min
- 1
( /min)
Tightening when force and
speed are d esired .
Tightening wood screws,
tightening b olts.
Low
2, 000 min
- 1
( /min)
Tightening with less force to
avoid screw thread b reak age.
Tightening sash screws, tight-
ening small screws such as M6.
127(
A mod e is availab le only when the tool rotates clock wise. W hen rotating counterclock wise in A mod e, the
impact force and speed are the same as hard mod e.
127(
W hen all lamps on the switch panel go out, the tool is turned off to save the b attery power. The impact force
grad e can b e check ed b y pulling the switch trigger to the extent that the tool d oes not operate.
127(
W hile pulling the switch trigger, the impact force grad e cannot b e changed .
+LJK
/RZ
Change
only when
running !
Only Clockwise !
+LJK
/RZ
Change
only when
running !
Only Clockwise !
High
Low
+LJK
/RZ
Change
only when
running !
Only Clockwise !
+LJK
/RZ
Change
only when
running !
Only Clockwise !
,PSDFWIRUFHJUDGHGLVSOD\HG
RQSDQHO
0D[LPXPEORZV
$SSOLFDWLRQ
:RUN
3, 300 min
2, 000 min
- 1
( /min)
Tightening when force and
speed are d esired .
Assemb ling the steel frame.
ad j ustment with small d iameter
b olt.
Assemb ling furnitures.
+LJK
/RZ
Change
only when
running !
Only Clockwise !
_(QJOLVK
B
A
1
