Industrial Shields M-DUINO PLC ARDUINO ETHERNET 58, Руководство пользователя

Страница: 35 / 54

Ref. IS.MDUINO.58+ Rev. 0: 30-08-2019
34
A Zone Features: Communications & RTC & uSD 10
10.1 RS-232
The Arduino Mega function code to access the RS-232 port in the M-Duino is Serial2 (pins 16
and 17 of the Arduino Mega).
For the RS-232 communication protocol there isn’t any switch that affects it. So it does not
matter the configuration of the switches to implement a RS-232 communication.
Using the boards of Industrial Shields, there is a library that simplifies the RS-232
implementation.
10.2 RS-485
For RS485 communication protocol the defined Arduino Mega pins are showed in the chart
below.
Function Arduino Pin
DI 14
RO 15
RE 11
DE 46
For the RS-485 communication protocol there is only one switch that affects in this
communication. The RS-485 protocol will be always enabled, the only switch that affects is the
one called “FD rs-485 HD” (See Section 8). This switch makes the choosing between RS-485
Half Duplex or RS-485 Full Duplex (RS-422).
Using the boards of Industrial Shields, there is a library that simplifies the RS-485
implementation.
10.3 I2C
I2C communication DOES NOT REQUIRE a pull-up resistor for the M-Duino 58 I/Os PLUS. The
pull-up resistor is already implemented in the PCB.
I2C communication is configured by switches, so the switches must be configured in order to
enable the I2C communication.
Switch ON OFF
D ZONE
SCL/I2.6 I2.6 SCL
SDA/I2.5 I2.5 SDA