96
Charging
Rear insert position
Forward insert position
Place the battery
against the
case bottom.
Using a torx screwdriver,
tighten the screws. See Table
8.1 for torque value.
If the charger includes an insert, adjust the insert to ensure
the battery contacts touch the charging contacts. Once the
insert is placed into the desired position, a firm push down
will secure it in place.
To prevent losing the insert, keep it in the cradle in the most
often used position.
Insert position: forward
Insert side: 1
Lithium-ion battery
Slim extended lithium-ion
battery
Extended range lithium-ion
battery (aspirated shown)
Insert position: forward
Insert side: 1
Insert position: forward
Insert side: 2
Insert position: rear
Insert side: 1
NOTE:
Do NOT touch the charger's battery contacts as contaminants and damage will inhibit charging.
Figure 8.3 Service Tasks
Warranty
Industrial Scientific Corporation’s Ventis™ Pro Series portable gas monitors are warranted to be free from
defects in material and workmanship under normal and proper use and service for as long as the
instrument is supported by Industrial Scientific (excludes sensors, batteries, filters, and pumps). O2, LEL,
CO (excluding COSH or CO/H2 Low), and H2S sensors are warranted for three years from date of
shipment. All other sensors, pumps, filters and battery packs are warranted for two years from date of
shipment, except where otherwise stated in writing in the literature accompanying the product.
Limitation of Liability
THE WARRANTY SET FORTH ABOVE IS STRICTLY LIMITED TO ITS TERMS AND IS IN LIEU OF ALL
OTHER WARRANTIES, GUARANTEES, EXPRESS OR IMPLIED, ARISING BY OPERATION OF LAW,
COURSE OF DEALING, USAGE OF TRADE OR OTHERWISE. INDUSTRIAL SCIENTIFIC MAKES NO
OTHER WARRANTIES, EITHER EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE
WARRANTIES OF MERCHANTABILITY OR FITNESS FOR PARTICULAR PURPOSE.
SHOULD THE PRODUCT FAIL TO CONFORM TO THE ABOVE WARRANTY, BUYER’S ONLY REMEDY
AND INDUSTRIAL SCIENTIFIC’S ONLY OBLIGATION SHALL BE, AT INDUSTRIAL SCIENTIFIC’S SOLE