Receiving and Uncrating of your Compressor
Before uncrating the compressor the following steps should be taken.
1. Immediately upon receipt of the equipment, it should be inspected for damage that may have occurred
during shipment. If any damage is found, demand an inspection immediately by an inspector from the
carrier. Ask him how to file a claim for damages. (See Appendix “A” for Details).
2. Insure that adequate lifting equipment is available for moving the machinery.
3. Read the compressor nameplate to be sure the compressor is the model and size ordered.
4. Read the motor nameplate to be sure the motor is compatible with your electrical conditions. (Volts-
Phase-Hertz).
NOTE: Standard motors are open drip proof with a maximum ambient temperature
rating of 104 degrees F. They are not suitable for salt laden, corrosive, dirty, wet, or
explosive environments.
IMPORTANT: If voltage supplied to the compressor is below 208 volts the unit need
a 200 Volt drive motor and 208-230-460 Volt should not be used below 208 volts.
Improper lifting can result in component or
system damage or personal injury. Follow
good shop practices and safety procedures
!
CAUTION
Under no circumstances should a compressor be placed
in an area that may be exposed to a flammable, toxic,
volatile or corrosive atmosphere nor should flammable,
toxic, volatile or corrosive agents be stored near the
compressor.
!
CAUTION
Industrial Gold Air Compressors
|
800-531-9656
| www.industrialgold.com
7.5, 10, 15 HP Electric Reciprocating Compressor
