Service Manual
Manual LFT 114 - 116 - 216
Edition
2007.10.15
Language
English
10
4.3 HOW TO USE
Starting a Programme-Cycle:
Press consecutively push-button “P” and close dishwasher. After a few seconds a “Beep” will be heard signalling that the selected
programme is about to start.
How to reset a programme-cycle underway
Open the dishwasher-door paying attention to any water that may leak out. Keep the On/Off-button
pressed for a while, a long sounding “Beep” will be given signalling that the programme has been reset.
NB: On the previous model EVO3, the programme was reset by pressing button “P”, which is the button used to
select the programme, for a while. A REMINDER: BY PRESSING “P” ON MODEL EOS, THE MODE ON WATER-
HARDNESS WILL HAVE BEEN SELECTED AND NOT THAT THE PROGRAMME WILL HAVE BEEN RESET.
Modifying a programme:
Open the dishwasher door paying attention to any water that may leak out. Keep the On/off button pressed for a while,a long-
sounding “Beep” will be given.
Switch the LVS on again, select the new programme and close the dish-washer door.
Adding more dishes to wash up:
Open the
dishwasher door, paying attention to any water that may leak out. Put in the dishes and close the door.
Accidental Interruptions
Interruptions will occur whenever the door is opened, or whenever the electricity has been cut off. Once the door has
been closed again and the electricity is back, the dishwasher will take up functioning again from where it had left off.
