27
The rotisserie (only a few models)
To operate the rotisserie, proceed as follows:
a) place the dripping-pan on the 1st rack;
b) insert the special rotisserie support on the 4th rack and
position the spit by inserting it through the special hole
into the rotisserie at the back of the oven;
c) to start the spit, set the oven selection knob (L)
Practical advice for burner use
In order to get the maximum yield it is important to remember
the following:
•
Use appropriate cookware for each burner (see table) so
as to avoid flames overshooting the edges.
•
At boiling point turn the knob to minimum.
•
Use cookware with lids.
•
Always use cookware with flat bottoms.
Storage recess below the oven
Below the oven a recess can be used to contain cooking pans
and cooker accessories. Moreover, during oven operation, it may
be used to keep food warm.To open the storage is necessary
turn it downwards.
Caution: this storage recess must
not be used to store inflammable
materials.
Burner
ø Cookware diameter (cm)
Fast (R)
24 - 26
Semi Fast (S)
16 - 20
Auxiliary (A)
10 - 14
The electronic timer displays the time and the timer function
with countdown.
Note: all the functions are operative approximately 7
seconds after they are stet.
How to reset the clock
After the appliance has been connected to the power supply,
or when the power has gone out, the clock display will
automatically reset to 0:00 and begin to blink. 0 00
•
Press the
v
button, and then use the
s
and
t
buttons to set the correct time. To move the time
forward quickly, keep the buttons pressed.
Whenever the time must be reset, follow this same
procedure.
Timer Feature
Press the
n
button to access this function. The symbol
“
n
” will appear on the display. Each time you press button
t
, the time will increase by 10 seconds until 99 minutes
and 50 seconds. If you continue to press it, the time will
increase from minute to minute up to a maximum of 10
hours.
Use button
s
to go backwards.
After setting the desired time, start the countdown. When
the time has elapsed, the buzzer will sound, and it can be
interrupted by pressing any of the buttons.
You can display the time by pressing button
v
, and symbol
“
n
” indicates the timer function has been set. After
approximately 7 seconds, the display automatically goes
back to indicating the timer.
To cancel a previous setting
Press button
s
up until 0 • 00.
Buzzer volume control
Once you have made and confirmed the clock settings,
use button
s
to adjust the volume of the alarm buzzer.
Electronic timer
