Indesit IHT6.5CMIX, Информация о сервисе

Страница: 14 / 25

14 of 25
Service Manual UK
Whirlpool UK Appliances Ltd
English
INSTALLATION
ELECTRICAL CONNECTION
The mains voltage must match that given on the ratings label inside the hood itself. If the hood has a
power plug, connect the hood to an easily accessible regulatory power socket. If it does not (direct
connection to the mains), or the socket is not easily accessible, install a two-pole regulatory switch to
enable total disconnection from the mains in case of category III over voltage, as required by the
installation regulations.
Caution! Always check that the mains cable is connected up properly and check that it operates
correctly before reconnecting the hood to the mains.
Air Exhaust (for Ducted Units)
Connect the hood to a duct and wall exhaust hole of a diameter equal to that of the air outlet flange.
Using a smaller diameter tube and exhaust hole reduces the extraction capacity of the hood and also
increases its running noise.
The manufacturer is not liable for any consequences of doing so.
•
Use the shortest duct required to achieve the purpose.
• Use a duct with as few bends as possible.
• Avoid suddenly changing the diameter of the duct.
• The duct must have as smooth an inner surface as possible.
• The duct must be made of regulatory material.
• Do not connect the hood to flues carrying combustion fumes from other equipment (boilers,
chimneys, stoves, etc.).
• Observe the instructions of the competent authorities in relation to the air exhaust. The air being
exhausted may not be exhausted into a wall cavity unless the cavity in question is specifically
intended for this purpose.
• Equip the room with air intakes to prevent the hood creating suction pressure in the interior (this
must not exceed 0.04 mbar).
• The manufacturer is not liable for any consequences of failure to observe these instructions.
Filter or Ducted?
Your hood is supplied as a ducted unit.
If you wish to use it as a filter unit, you must install the proper ACCESSORY KIT.
Note: Supplied with the hood (not IHT6.5CMIX & IHT6.5SCMIX), the accessory active charcoal filter
unit may already be installed.
Instructions for transforming the hood from the ducted to the filter version are given in this manual
See 'Filter Version'.
Ducted Version
The hood purifies the air and expels it outdoors via an exhaust duct (diameter 150mm) connected to
its outlet flange.
The diameter of the exhaust tube must be equal to that of the outlet flange.
Caution! The exhaust duct is not supplied and must be purchased separately.
When routed horizontally, the tube must be angled slightly upwards (around 10°) to enable the air to
be conveyed more easily. If the hood is fitted with charcoal filters, they must first be removed.