Indesit BAAN 40 FNF WD xx (TK), Руководство по эксплуатации, Страница: 9 / 16

GB
9
c) The alarm sounds and the two yellow indicator lights as
well as the green one flash.
c) The temperature in the freezer has reached a dangerous
level. The food must be disposed immediately.
+ buzzer =
Heating danger
b/c) In the first case the freezer will maintain a temperature of
about 0°C so that the food does not re-freeze. In the second
case, however, the temperature will remain at approximately
-18°C. To turn off the acoustic signal open and close the
refrigerator door. To restore normal operation bring the FREEZER
OPERATION knob setting to (off) and turn the appliance on
again.
The green POWER indicator light flashes.
• The appliance is not operating correctly. Contact the
Technical Assistance Centre.
The refrigerator and the freezer do not cool well.
• The doors do not close properly or the seals are damaged.
• The doors are opened too frequently.
• The OPERATION knobs are not on the correct setting (see
Description).
• The refrigerator or the freezer have been over-filled.
The food inside the refrigerator is beginning to freeze.
• The REFRIGERATOR OPERATION knob is not on the correct
setting (see Description).
• The food is in contact with the back inside wall of the
refrigerator.
The motor runs continuously.
• The SUPER FREEZE button has been pressed (rapid
freezing): the yellow SUPER FREEZE light is on or flashing
(see Description).
• The door is not closed properly or is continuously opened.
• The outside ambient temperature is very high.
• The thickness of the frost exceeds 2-3 mm (see
Maintenance).
The appliance makes a lot of noise.
• The appliance has not been installed on a level surface (see
Installation).
• The appliance has been installed between cabinets that
vibrate and make noise.
• The internal refrigerant makes a slight noise even when the
compressor is off. This is not a defect, it is normal.
Some of the external parts of the refrigerator become hot
• Temperaturile ridicate sunt necesare pentru a evita formarea
apei de condens în anumite zone ale produsului.