WARRANTY CERTIFICATE
Product
:
PPR PIPE WELDING MACHINE WITH CLAMPING
Identification
:
Type Designation : P-392A
LIMITED ONE YEAR WARRANTY AGAINST MANUFACTURING DEFECT.
Makes every effort to assure that its
PPR PIPE WELDING MACHINE
WITH CLAMPING
meet high quality and durability standards and warrants to the original
purchaser that the product is free from defects in material and workmanship for the period
of one year form the date of purchase. This warranty does not apply to damage due directly
or indirectly to misuse, abuse, negligence or accidental repairs or alteration outside our
facilities, or to lack or indignance. We shall in no event be liable for death, injuries to person
or property or for incidental contingent, special or consequential damages arising from the
use of our product. Some states don't allow the exclusion or limitation of incidental or
consequential dames, so the above limitation of exclusion may not apply to you.
To take advantages of this warranty, the product or part must be returned to us with
transportation charges pre-paid. Proof of purchase date and an explanation of the
complaint must accompany the merchandise. If our inspection very the defect, we will
either repair or replace the product all elecrole or we may elect to refund the purchase price
if we cannot readily and quickly provide you with replacement. We well return repaired
products all our expense, but if we determine there is no defect, or that the defect resulted
from caused no within the scope of our warranty, then you must bear the cost of returning
the product.
This warranty gives you specific legal right and you may also have other rights which vary
from state to state.
6
91257
4
o
N
*
Accredited
by the Rv
A
SINCE 1958
POWER
Page # 2 - M:392A
Prod. No.
392A
Size (mm)
63 - 160
Spec.
220V/50Hz., 270°C, 1750W
No. of Dies
63, 75, 90, 110, 160
Page # 3 - M:392A
PPR PIPE WELDING MACHINE WITH CLAMPING INSTRUCTION
MANUAL
FEATURE :
It is electric portable device which is used to weld PPR, Pipes
Size 63-16mm at sight during installation with joints.
I. Safety Requirements
1.
Fix the Pipe to the clamp at left end, leave certain length according to actual situation and fix the fitting to the
active stand at right end.
2.
Choose the welded head of same size as the pipe you need to weld, put the coneave welded head to the left side
of the heated board and protruding one to right then fix up the screw (M8*50) to the heated board which is
electrified, heating the electricity (the temperature is controlled automatically to 250º +15º, red light on when
the electricity is on, operate when the green light is on while the red one is off).
3.
When the green light is on, then we can operate and when the pipe and fitting are melt down, shaking the hand
sheel welding the pipe and fitting when their sizes are suitable for needing, keep them heating about 30
minutes.
4.
Exit the welded nould fast, press and weld the pipe and the fitting, the welding is over when the temperature
drops down at normal in room.
Welding Heads
Welding Heater
Flange Pipe Clamp
Red Light
Green Light
Screw Handle
Flange Clamp
Handle Grip
Feeding Screw
Pipe Clamp
