Indel B BREEZE T30, Инструкция по эксплуатации

Страница: 12 / 34

12
BREEZE T30 - T40 220V
BREEZE T30-T40_(220V)_IM_20190429
USE
When connecting the plug to the mains outlet, the minibar starts operating immediately, unless the
temperature adjusting knob is set to ”0” (zero)” (see figure 03).
TEMPERATURE SETTING
The knob for the temperature adjusting thermostat is located in the upper part of the internal liner of the
refrigerator.
To set the internal temperature, adjust the control knob according to the ambient temperature or based on
the use the refrigerator is intended to.
The temperature control range is comprised of the following levels:
• position 0 = refrigerator off
• position 1 = minimal refrigeration (higher internal temperature)
• position 2 = medium refrigeration (intermediate internal temperature)
• position 3 = maximum refrigeration (lower internal temperature)
In the niche versions, the door can be hooked onto the leaf of the cabinet housing through the drawing line
which allows for simultaneous opening (dragging system).
APPLYING THE DRAFT
(see figure 04)
The draft is a device - consisting of two parts, A and B - which connects the door of the Minibar to the door
of the piece of furniture it is fitted into, both when opening and when closing.
To install the draft, proceed as follows:
• screw the part A onto the door of the Minibar;
• open the door of the Minibar by 90°;
• screw the part B, perfectly horizontal, to the inside of the leaf of the piece of furniture, and fit it into the
part A so it can work as a sliding guide;
• fasten the lower part of the refrigerator to the base of the cabinet containing it by means of the brackets
C.
REVERSING THE DOOR OPENING SIDE
(see figure 05)
In the built-in models, the door can be hooked to the door of the cabinet housing it through a special towing
device, which enables simultaneous opening (dragging system). In the case where the door opens on the
opposite side to the cabinet door, it can be reversed as follows:
• remove the cover D;
• undo the screws holding the pin E to the fridge structure;
• remove the cover F;
• screw the pin E into the position previously occupied by the cover F;
• reposition the cover D above the pin E and the cover F on the opposite side of the structure.