RECEIVING
:
Before removing any packing, visually inspect the exterior of the shipment for any sign of damage. Should there be any
damage, bring it to the attention of the delivering UPS or truck line and note the same on the receiving ticket. Should there be
damage you must place a claim with the truck line. They are the only ones who will pay for the damage done and you are the
only one who can place that claim.
INSTALLATION:
Frame Bracket Assembly
Mounting bracket assembles to fit 34” to 48” wide Intermediate Bulk Containers (IBC) “totes” and other containers in this size
range. Two hand-knobs tighten bracket assembly to side of container.
Impeller Shaft - BT Series
To install mixer shaft, back off the set screws as far as possible without removing them. Insert mixing shaft into the coupler as
far as it will go. Tighten the set screws firmly to secure the shaft to the coupler.
Impeller Placement
For mixers with ONE impeller, mount it 1 to 2 impeller diameters distance off the bottom of mixing container.
For mixers with TWO or more impellers, mount the lowest impeller 1 to 2 impeller diameters distance off the bottom of mixing container.
Mount the other impellers 1 to 2 impeller diameters apart. The above guide-lines are “rules of thumb” and may not be the best for your
situation. Experimenting with impeller placement may provide your best results.
INDCO, Inc. • M-M-30105 mixer manual BT & BGF Series • 1/9/14 • Page 4 of 11
motor~gearbox
mounting plate
frame bracket
(small)
- adjustable -
hand-knob
frame bracket
(large)
34” to 48”
container size
6”
8.5”
BT
Series
set screws
impeller shaft
coupler,
mounted to
motor shaft
