8
Print Bed Setting
• During printing, fine-tune using Z Babysteping until proper adhesion is achieved
Advanced
• If you want to modify the number of points to be polled, you can make the changes from System / Config.g
• Go to ; Probe Z and change the P parameter of the following command
M557 X15:215 Y15:195P3:3
• You can also download or edit your heihtmap.csv file to correct any point or to save different height maps created
Below we will explain how to correctly change the nozzle.
1. Remove the material from the head
2. Unscrew the fitting and remove it together with the
bowden tube.
3. Remove the nozzle using the tool and fit the new one.
4. Make sure the tip is firmly attached to the head
5. IMPORTANT: Insert the tube into the head and check
that it enters to the correct area. (see image).
6. Screw the fitting a few turns, tighten the
flange and re-thread all the way.
Load Compression Map
• If you have restarted the printer, you must load the Height Map again, to do this, execute Load Height Compensation Map
saved in the SD card (G29 S1)
NOZZLE
CHANGE TOOL
