2
Use C-clamps to attach a 3/4” thick by
9” wide plywood or MDF base panel to
your router table …
Step 1. Attach the INCRA Jig to
your router table.
The INCRA Fence System is designed to
work as the “front end” to the INCRA Jig
Positioner, so the first step is to attach your
INCRA Jig to your router table. After
following the instructions in the INCRA Jig
owner’s manual for attaching your INCRA
Jig to a wooden base panel, use C-clamps
to attach the base panel to your router
table as shown in
Fig. 1
. If your router
table is “INCRA-ready” with built-in
mounting slots, you can use the bolt,
washer and knob combination shown in
Fig. 1A
for maximum versatility and ease
of use.
Fig. 1
… or, if your router table is
“INCRA-ready” with built-in
mounting slots, you can attach
the base panel with bolts,
washers and knobs for greater
ease of use
Attach wooden base panel
Router table
Base panel
Step 2. Attach the INCRA Fence to the
INCRA Jig
Open
hardware pack D-03
. Place a washer on each of
the (2) 1/4-20 x 1 1/4” socket head fasteners and
insert through the upper holes on the fence. Now
loosely thread on the 1/4-20 rectangular nuts.
CAUTION: The raised rim on the two rectangular
nuts MUST FACE AWAY from the fence, as
shown in Fig. 2
. Lower the rectangular nuts into the T-
slots located on the front end of the INCRA Jig, then
tighten the fasteners using the included 3/16” hex key.
1/4-20 rectangular
nut (2). Raised rim
MUST face AWAY from
the fence
1/4-20 x 1 1/4”
socket head cap
screw and washer
(2)
Fig. 3
Square Fence to the router table
Place shim between top of jig and
fence to decrease angle
Place shim between bottom of jig
and fence to increase angle
Square
Step 3. Square fence to router table.
After attaching your fence to the INCRA Jig, check
for squareness with your router table top. If any
adjustment is necessary, loosen the fence mounting
screws and insert a paper or plastic shim between
the INCRA Jig and the rear face of the fence,
Fig. 3
.
A shim placed
below
the fasteners will increase the
angle between the fence and the table. A shim
placed
above
the fasteners will decrease the angle.
Tighten the fasteners to secure the fence.
Fig. 1A
INCRA Fence & Stop - Assembly and Use
Fig. 2
Attach fence to the INCRA Jig
