For tech support please email [email protected]
Wire
29-UCCAB-005 Kenwood or JVC
BROWN wire to brown
Connect the Brown wire to the Blue/Yellow single wire on the Kenwood or JVC
marked STEERING WHEEL REMOTE INPUT
Wire
Wire
Or Tip
29-UCCAB-000 Chinese 2 wire or 29-UCCAB-016 Chinese 3.5 jack
PURPLE to Purple
BLACK to Black
Connect to the learning input wires on the head unit KEY1 and KEY Ground or
SWC1 and SWC Ground
Base
Tip
Ring
29-UCCAB-001 Alpine (CBL007UNA22)
BLACK Base to black
WHITE Ring to brown * 13.7K resistor inline
RED Tip to purple
Base
Tip
29-UCCAB-003 Clarion (CBL07UNJV12)
BLACK to Base black
RED Tip to brown
Base
Tip
Ring
29-UCCAB-007 Pioneer / Sony (CBL007UNPI12)
RED Tip to purple
WHITE Ring to brown
BLACK Base to black
BELOW are the wire entry side of the PATCH LEADS which will plug into the 4 way connector on the interface
Tip
Ring
Base
Connect the jack plug on these
patch leads to the SWC input
jack on the Aftermarket head-
unit
3
–the Reverse and Speed pulse cable
The blue reverse wire positive is needed only when connecting a camera to the new head-unit.
The grey speed pulse wire is needed on some Navigation aftermarket units.
TEST EVERYTHING
before fitting away neatly.
29-UCCAB patch lead wiring information
This is the wire entry side of the 4
way connector from the interface
box. The patch leads below will
plug into this connector
Base
1 - 2
2 - 3
J1
ALPINE,
PIONEER & SONY OUTPUT
(DEFAULT SETTING)
J2
NEG Handbrake (not all
vehicles)
J3
POSITIVE REVERSE OUTPUT
J4
J5
CAN-BUS HANDLING
Jumpers
The table below show the jumper settings that are important for Alpine, Pioneer, Sony or Chinese
radios. Kenwood and JVC and Clarion radios will work on either setting.
