Inalto ESL60D2S, Руководство пользователя

Страница: 20 / 28

20
Troubleshooting
OPERATION IN CASE OF EMERGENCY
In the event of an emergency you should:
• Switch off all rangehood controls.
• Switch the rangehood off at the power outlet and immediately unplug.
• Call After Sales Support.
Some minor faults can be fixed by referring to the instructions given in the table below.
IMPORTANT: If your appliance appears to be operating incorrectly, then you should disconnect it
from your electrical supply and then contact After Sales Support.
WARNING:
Do not attempt to repair the rangehood yourself.
Please note that if an engineer is asked to attend whilst the product is under warranty and finds that the
problem is not the result of an appliance fault, then you may be liable for the cost of the call out charge.
The appliance must be accessible for the engineer to perform any necessary repair.
If your appliance is installed in such a way that an engineer is concerned that damage will be caused
to the appliance or your kitchen, then they will not complete a repair. This includes situations where
the rangehood has been tiled in or sealed in with a sealant.
Please refer to the conditions of that appear on the warranty card at the rear of this user manual.
FAULT POSSIBLE CAUSE COMMON SOLUTIONS
The extractor
fan ceases to
function
There is no electrical current
in the network
Check with other appliances
that your electricity supply is
in working order
There is
insufficient
suction power
Wrong suction speed has
been selected
Select suction speed “ II ”
if speed “ I ” was selected
Ducting is loose, kinked, too long
or too many bends
Make sure your kitchen is adequately vented to allow
the entry of fresh air
The charcoal filter needs to be
replaced.
Please replace charcoal filter if food odour start
to become noticeable within your kitchen
The distance between the range-
hood and your cooktop is too great
Have your installer re-adjust the installation position,
ensuring that the minimum distances are observed
as per the building code and relevant standards
The rangehood
has lost power
during operation
The switch board may have tripped Check the switch board
Check if the rangehood has been
installed below the height levels
indicated in the “Installation” section
Re-installation may be required.
If the height recommendations are not followed,
the motor will cut out frequently, which may
damage the rangehood
The light does not
illuminate
The bulbs are loose, or have burnt out Tighten the bulbs, or replace if necessary