Inalto ESL60D2S, Руководство пользователя

Страница: 15 / 28

15
REAR-MOUNTING TO THE WALL
• Using a spirit level, mark a horizontal line on the wall where the rangehood base
will be, adhering to the minimum and maximum distances from the rangehood base
to the cooktop surface (as per table on page 12).
• Drill 4 holes of Ø8mm on the wall, as illustrated below (Figure 7).
• Hammer the wall plugs into the holes, then insert two ST4×30mm screws
into the lower wall plugs.
• Tighten the screws, but leave a 2mm gap so that you can hang the rangehood
on the screws in the keyhole slots.
• Hang the rangehood to the wall screws, and make sure the hood is in balance
and positioned correctly.
• Take away the Aluminum Filters, mark and drill another 2 holes of Ø8mm
on the wall (Safety Screw Holes).
• Take back the hood and hammer the wall plugs, hang the hood again and fix the hood
with two ST4×30mm screws.
WARNING:
Failure to install the screws or fixing device in accordance with these instructions
may result in electrical hazards!
Figure 7
Installation height:
For optimum performance, it is recommended that the rangehood be installed at a height of
between 650-750mm from the cooking surface. See Fig. for detailed AS/NZS minimum distance
requirements.
Rear-mounting to the wall
• Using a spirit level, mark a horizontal line on the wall where the rangehood base will be, observing
all necessary clearances (Fig. ). Check the required clearances in your cooktop/stove manual and,
should they be greater than those specifi ed in Fig. , make sure to observe them.
Fig.
Minimum distance
– Electric: 600mm
– Gas: 650mm
Maximum distance
– Either: 750mm
Top of
cooktop
Rangehood base
• Drill 4 holes of Ø8mm on the wall, as illustrated below (Fig. ).
• Hammer the wall plugs into the holes, then insert two ST4x30mm screws into the lower wall plugs.
Tighten the screws, but leave a 2mm gap so that you can hang the rangehood on the screws in the
keyhole slots.
• Hang the hood to the wall screws, and make sure the hood is in balance and positioned correctly.
• Take away the Aluminum Filters, mark and drill another 2 holes of Ø8mm on the wall . (Safety Screw
Holes)
• Take back the hood and hammer the wall plugs, hang the hood again and fi x the hood with two
ST4x30mm screws.
WARNING: Failure to install the screws or fi xing device in accordance with these instructions may
result in electrical hazards!
Fig.