4
MIG PRO 41/35 : Foreside (Lower part)
Generator
wire
feeder
(connected to positive terminal).
Selection commutators of the output
voltage.
Gas
connection
allows to lay in gas
generator
wire
feeder type WF. The
connection
is
situated near to the
motor
Terminal – to use a
superior current 200 A
(position for an using in
SPRAY ARC).
Operating connector
for application with
a separated wire
feeder type WF.
Positive terminal for
an application with a
separated
wire
feeder type WF.
Commutator on wire feeder choice.
Position I: generator wire feeder (origin).
Position II: separated wire feeder WF 212, 324 or 344 W (in option).
Terminal – application on
weak Thickness (current
inferior to 200 A)
IV / COMMISSIONING
4-1)
Mains connection
See paragraph III.
4-2) Connection to gas bottle and gas choice
Screw down the regulator on gas bottle. This one is connected to MAGYS and GENEGYS by a pipe
whose terminal end is fixated on the electronic valve behind the machine. You must use clamps to
avoid escape of gas.
MIG PRO 41/35
Application with the wire feeder of the generator
Application with a separated wire feeder typ WF
Screw down the gas connection from moto
generator wire feeder on the gas connection
Screw off the pipe of moto generator wire feeder
and screw down bank connection by integrating
the pipe in the front side hole.
Gas choice
:
:
STEEL MORE OR LESS ALLOYED
-
Pure CO2 (not much used),
-
Argon + CO2 (universal gas, often used),
-
Argon + CO2 + O2 (not much used).