Visit www.improvedracing.com for additional support
10
Figure 8 - Trimmed Fascia Panel Installed
coMPleting tHe installation
1. Check that all lines and fittings are snug.
2. Check the engine oil level and add oil if necessary.
3. Refill the engine’s coolant system using the manufacturer’s approved
method for your specific vehicle.
Tip:
Consult the vehicle’s factory service manual for the correct coolant
specifications and refill procedure.
4. Start the vehicle and inspect for oil and coolant leaks.
IMPORTANT: Check that the engine has oil pressure immediately after
startup. If the oil pressure is abnormal or if the engine makes excessive
noise that does not subside within 3-5 seconds, turn off the engine
immediately and check the oil line connections for routing errors or a
kinked oil line.
5. Turn-off the vehicle, inspect the engine oil and coolant levels and add
oil or coolant as needed.
6. Reinstall the front bumper and all underbody panels. Lower the vehicle
back onto the ground.
7. Inspect lines and fittings for leaks after one heat cycle. If any leaks are
detected, re-tighten the fittings until the leak is eliminated.
